How to fix code f35 on sears washer he5

How to fix code f35 on sears washer he5

Uh oh! The Dreaded "F35" Error on Your Sears HE5 Washer

Seeing that "F35" pop up on your Sears HE5 washer's display can induce a bit of panic. But don't worry! It usually means there's a hiccup with the analog pressure sensor (or water level sensor, as it's sometimes called). This little device lets your washer know how much water is inside, so it doesn't go overboard.

Before Calling the Pros: DIY Fixes

Let's walk through some troubleshooting steps that could save you money on a repair service visit.

Step 1: The Pressure Hose Check-Up

  • Power Down: Safety first! Unplug your washer.
  • Locate the Sensor: Look towards the back of your washer. The sensor is usually a small part with a little hose attached.
  • Inspect the Hose: Look for kinks, bends, or blockages. A clog can be the culprit, so use a small brush or pipe cleaner for a gentle clean.

Step 2: Cleaning that Sensor

  • Remove & Clean: Carefully detach the sensor by removing the hose and electrical connectors. Clean it gently with warm soapy water and a soft brush.
  • Rinse & Dry: Rinse thoroughly and let it dry completely before reattaching it.

Step 3: Wiring Woes?

  • Inspect connections: Ensure everything's tight and check for any fraying or broken wires. Replace if needed.

Step 4: Sensor Swap

If the steps above don't do the trick, a new sensor might be needed.

  • Get The Right Part: Visit Sears or an online appliance parts retailer and find the compatible sensor for your specific model.
  • Replacement Time: Carefully swap the old sensor with the new one.

Step 5: Reset with a Calibration Cycle

  • Manufacturer's Instructions: Refer to your manual for the exact process, but there's typically a specific cycle to run after a repair.

Extra Pointers

  • The Manual is Your Friend: There might be model-specific quirks in there, so give it a read.
  • Feeling Overwhelmed? A professional appliance technician is always an option if you're uncomfortable with DIY solutions.

Let's Beat That Error Code!

Hopefully, these steps help you clear that "F35" error code and get your Sears HE5 washer back on track. If the error persists, it could be a bit more complicated and might need professional attention.

Leave a Reply

Your email address will not be published. Required fields are marked *